Welcome

We have detected that you are coming from within the US.
Would you like to visit our LEGO Education North America site instead?

Please choose one of the following:

I would like to go to the LEGO Education North America site

I would like to stay on this site for now

Skip Navigation Links

FAQ and Technical Support


  • How do I get started
  • A: Read the information sheet inside the set or download the User Guide from Legoeducation.com and follow the instructions. Be sure to charge and discharge the Energy Meter three times before using it the first time, in order to optimize the efficiency of the Energy Storage. It is important that you separate the Energy Display and Energy Storage after use. This will maintain the level of charge for longer.


  • Renewable Energy Set and MINDSTORMS
  • A: Go to MINDSTORMSeducation.com and download the free block, activities and building instructions.


  • Using the Energy Meter
  • A: Remove the battery, wait for 5 minutes, and then replace the battery and try again.

  • A: You can use the Energy Meter until the lightning sign is lit continuously (not flashing). From the time the lightning sign starts flashing until the sign shows continuously you will have up to 1 hour of use. This should be plenty of time in which to finish your testing.

  • A: You can charge the Energy Meter in any one of three ways (see the information sheet for further details):

    1. By using the Power Functions Battery Box

    2. By using the Power Functions Rechargeable Battery Box

    3. By using the NXT

  • A: When the lightning sign in the display starts to flash, it is a signal that you will need to charge the Energy Meter after you have finished your class or experiment. If the lightning sign remains on continuously (not flashing), then you need to charge the unit immediately. We recommend charging the Energy Meter after each session.

  • A: If you charge the Energy Meter immediately the lightning sign starts flashing, it will take approximately 1 hour to charge fully. If the lightning sign is showing continuously, then it will take up to 3 hours to charge the Energy Meter fully. The Energy Meter is fully charged when the display turns off.

  • A: Depending on the use made of the Energy Meter and the conditions under which it is stored, it can be used for more than 2½ hours of testing, the exact length of time depending on the level of activity. If the Energy Meter is not used at all, if it is fully charged and if the Energy Display and Energy Storage are stored separately, the charge will run out after approximately 3 months.

  • A: The Energy Meter has been overloaded. This can occur if a motor connected to the output plug has jammed. (please consult the information sheet in the set)

  • A: When an energy source is connected to the input plug on the back of the Energy Meter you can read the current input in volts, amps and watts at the top of the display. In the middle of the display you can read the accumulated joule level, which is the amount of energy you have stored. When the stored energy is used by connecting a motor or other device to the output plug on the front of the Energy Meter, you can read the current output in volts, amps and watts at the bottom of the display. In the middle of the display, the joule level of the stored energy will count down until all the energy is used.

  • A: The Energy Meter is intelligent. It will always try to draw as much energy from the source, e.g. the solar panel, as possible. This regulation/optimisation process will cause the readings to fluctuate.

  • A: The Energy Meter is programmed to work with small experiments, and consequently it stops measuring when the level of 100 joule is reached.

  • LEGO, the LEGO logo, the Minifigure, DUPLO, LEGENDS OF CHIMA, NINJAGO, BIONICLE, MINDSTORMS and MIXELS are trademarks and/or copyrights of the LEGO Group.
    ©2014 The LEGO Group. All rights reserved. Use of this site signifies your agreement to the terms of use.